Tech section strictly for the FJR. Everything from oil changes & suspension setup's to removing sheep hair from hard to reach places on the bike so that your wife never finds out.
I just received my PC-8 and wiring harness from eastern beaver. Anyone have an installation thread or video? I'm mounting it under the rear seat but...
Last post
Thanks. That's exactly what I did, I tapped into the tail light wire where the admore light kit connects. I just had to extend the trigger wire.
I...
Looking in to getting a fuse block (Eastern Beaver PC-8) and not 100% sure what size to get. Save a few bucks for extra Farkles and get the 30 AMP or...
Last post
Ummmmm, We already discussed this, and I went back and changed that. Now you're continuing to spread bad information. Way to go!
So I am in the process of mounting a Garmin Zumo 590 to my bike. The provided harness had leads to wire directly to the battery. My question is, with...
Last post
This weekend? I thought you were headed down a week from Saturday?
I have about two weeks left on my extended warranty and noticed the right head light was out. (Throttle side) I was able to reach my hand in, just...
Last post
Did another ever so slight push outward to the contacts before I saw the above post. Fortunately nothing broke. After doing that the flickers stopped...
Anyone out there have any preference for aftermarket front suspension upgrades?
Last post
The Gen 3 is surprisingly good. However, if you are a big boy, and ride hard, then aftermarket might be the route to go. I don't ride very hard most...
This past trip, I got into a batch of fresh road tar, apparently. Before I go crazy trying a bunch of stupid crap, can anyone tell me what they have...
Last post
Mineral spirits and for tougher spots, I break out the lacquer thinner.
I am in the process of installing traxxion fork springs on my 14A. I got something wrong or the springs are incorrect. On the adjustable fork, it is...
Last post
I see the problem: Your forks are right side up!
Curious, what weight springs did you go with, and what other work did you do on them?
Hello - I'm new to the Forum, Canadian with new 2016 FJR1300A. If somebody could help me and tell me how to post a pm, I would appreciate it. Have no...
I couldn't find any concrete answers on this, but would a Gen1 Aftermarket shock (Ohlins/Penske) work on a Gen3 A?
Last post
I agree the basic shock will fit all Gen's, where you have issues is with an onboard reservoir, but anything with hoses (remote reservoir) should be...
So I'm out for a ride searching BMI bonii and at one stop my emergency flashers won't shut off. Don't know if the button is stuck (doesn't feel like...
Last post
They came on so you didn't get run over by a Gen 2...
Got a question for anyone with experience using Dynabeads in their tires. I just mounted a new set of PR4's on the bike. I seem to have a rumble at...
Last post
Wheat,
I'm sorta with you. Don't run 155, because I'm just too old to waste my time behind bars. LOL
If one does understand the laws of physics, you...
The replacement job shouldn't be difficult, especially as the forks are out already and being rebuilt.
My...
Last post
I used a Dremel with a grinder stone on it and cut most of the way through, as far as I dared without touching the shaft with the grinder, and then a...
Ok...In all honesty my plan was to comment on a couple posts to get my count above 5 and open the secret doors but I realize that much of the content...
Last post
I had words with your old mechanic and it's all coming back to him now... he says you (we) didn't pour in too fast, and while we blipped the throttle...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum
