Tech section strictly for the FJR. Everything from oil changes & suspension setup's to removing sheep hair from hard to reach places on the bike so that your wife never finds out.
Heated, froze, used a BFH to seat the bearing. Got some serious air and seated them more.
Tightened steering again old school by hand. Put on some...
Last post
My All Balls tapered head bearing tq is 17 lbs. I started at 25 lbs and it felt like a low tire the way it wandered around (to tight) then backed off...
Hi. New to the forum and the FJR. Saved the bike from going to the auction so price wasn't bad and as it has been stood I am expecting a few issues....
Last post
If we haven't heard anything in 2 years I assume it's either fixed or the bike has been scrapped.
Is there anyone in the upstate SC area who has any experience with a good auto body painter? I'm looking for someone to fix some scratches on my 14...
Last post
I just left the rash. Gives me stories to tell. Plus, at resale time, I save the cost of repairing. Theirs a reverse psychology going on when you buy...
Getting ready to flush the brake and clutch systems on a 2018A. How much brake fluid should I have on...
Last post
You can mix. Many buy too much fluid and have to toss it if they don't keep it sealed up.... being your '18 ain't that old, it ain't needing repeated...
KrZy8 has developed a pretty significant stumble off idle, but not all the time! Seems more prevalent when hot.
significant stumble off idle
as...
Last post
ha... trapped gasket...... just coulda loosened it, lift it enough to get it in the groove and re-snug it back up. Iff'n ya cut it, still might work...
I am just trying to get acclimated to my 2016 FJR and am wondering about being able to use my Slime Digital Tire Inflator with the 12v socket. It has...
Last post
Note for new members.
DO NOT LET JWILLY SIT ON YOUR BIKE After he has been at the Tiki bar...
Years ago I did some in-depth testing of various oil filters, comparing flow rates, pressures, filtration, capacity, etc. I found that the Bosch 3323...
Last post
I too prefer the lathe over the belt sander. I took a half-millimeter off because I figured I needed another 1/2 turn for a good seal and while I can...
I was walking by my '16ES (35K miles) last week and I noticed a few drops oil on the floor just ahead of the pumpkin. Upon closer inspection I found...
Last post
Same pumpkin, go for it.
(It's not, but physically same, will bolt on).
Existing seal should not catastrophically fail.
OK. Naomi's (2013) cams need to come out. It's been more than 30 seconds since I lifted cams in the 2006 (KrZy8) and now I are cornfused.
When I...
Last post
Dowel in the left tensioner, right tensioner will slide up. I do the KrZy8 method, zip the chain on the left, around the tensioner on the right, keep...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum
