I had to give up my wynpro Bigfoot on the 2018. Too much scraping. I’d do a couple of these.
You definitely need to check your suspension then. Or...
Last post
I didn’t have much of a problem with my Bigfoot until I started riding with the wrong crowd...
Nothing makes my day like a bunch of old guys talking...
Pulling into the hotel in Logan UT last nite heard a grinding sound from the ft. brake. Inside pad on left caliper appears to be shot. Left a message...
Last post
Awesomeness!! See you soon. I’ll double check their work.
I bought my 2016 about 3 months ago and found with the stock shield the wind noise/buffeting rather excessive even with earplugs so I bought the tall...
Last post
What I did for the Honda is order this deflector (the wider one), and it clamps on securely and is fully adjustable. The acrylic does not appear to...
I’ve always set my levers to the “number” on the dial that put the lever where it felt good to me.
Is there any...
Last post
Once the cast is on, the fingers will be all together. Right now, waiting on the swelling to go down enough to allow for a cast. I figure giving the...
I've noticed that my pegs seemed to be sagging a little bit lately. Tonight I pulled my left side peg off to inspect and below is what i found. 2016...
Last post
Hmmmmm. yeah. that's it. riding two up. Couldn't have anything to do with someone we know dragging that peg around the corners at all, could it?...
This post will likely be a waste of your time if you already have a current rev, 6 speed, ES bike. Heck, it'll probably be wasted reading for anybody...
Last post
First valve check in 11 months? Ride on, man - serious respect!!!
I got back from a great 5 day trip through the Appalachians and removed the rear wheel to replace the tire. Once off the bike, I noticed a small dent...
Last post
I used a piece of wood and a hammer to straighten out the dent. Most of the dent came out and I had a new tire mounted and balanced so all is good...
2016 year but i assume it doesnt matter. Did a quick wash and found a small dent and small crack in the headlight lens. Feels like a pin head size...
Last post
I have some weldon4 on the way to seal the crack. I think putting it in with toothpick will work as i should only need a hint of the stuff since the...
Buddy just bought a clean 15 ES with 20K. Complains of front end looseness, shop checked stem bearings as OK. Front tire has some cupping. Looks like...
Last post
He tried all the settings. I rode it after drinking.
How many folks build the frame out of cast iron pipe like the one made by Bryan Glynn to hold up their bikes while they perform the centre stand etc...
Last post
I have a tall 42 steel sawhorse with extendable legs that fits right over the rear end... as far as rafters don't worry much you're only lifting 300...
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum
